algorithmic modeling for Rhino
Culling points based on proximity to curve start/end
I'm wrestling with how to cull a list of points based on a list of curves. I need to cull those points that are on one of the curves and that are too close to a given distance from that curves start or end points. Any suggestions?
Views: 3205
Replies to This Discussion
-
Permalink Reply by David Rutten on
-
Hi Anton,
it sounds like two separate culling operations. First I'd remove all points that have a distance of less than some small number to the curve. You can use the Curve CP component to measure this distance.
Then collect all end-points into a single list and use the Pull Point or Closest Point for that. -
-
Permalink Reply by Anton Bakker on
-
Got it, works!
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Space Frame
Added by Parametric House 0 Comments 0 Likes
-
Voronoi Mesh
Added by Parametric House 0 Comments 0 Likes
-
Inflated Mesh
Added by Parametric House 0 Comments 0 Likes
© 2025 Created by Scott Davidson.
Powered by
