Grasshopper

algorithmic modeling for Rhino

Cull Pattern Problem in making octagonal pattern

Hello

I've made pattern of octagons based on point grid. I used cull patterns and Tree Branch components. At the end I found out that the figures are not connected together but offsetted of 1 grid "cell". I'm wondering, how to modify my definition to encloser the octagons. I want them to "touch" themselves. Do you guys think that's possible without big changes? Is my way of doing this pattern correct ? 

Cull%20pattern-%20chi%C5%84ski%20pattern.gh

Views: 2123

Replies to This Discussion

Permalink Reply by Alan Tai on October 3, 2012 at 3:15am

09.0012

Permalink Reply by Kuba on October 3, 2012 at 4:19pm

super Alan Tai!!

What shift value did You use in each "shift" ? 

Permalink Reply by Kuba on October 4, 2012 at 2:27am

Understood finally :)  Thanks !! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service