Grasshopper

algorithmic modeling for Rhino

Cull All Edges From Brep Except Top Edge

Hello,

I am attempting to cull all the edges from a surface except the top one so I can create a perpendicular plane for it to rotate around. This way the surface rotates around its top edge..

I can cull most of the edges from an exploded Brep using CullNth, reversing the list and removing every second one. But I end up with the bottom curves I think.

What is the best way to remove all edges from a surface except the top one?

Thanks,

John

Views: 781

Replies to This Discussion

Permalink Reply by Chris Tietjen on November 21, 2012 at 6:33pm

Not sure if I'm understanding what you want to do...I'm going by the sentence, "This way the surface rotates around its top edge."

Permalink Reply by John Abowd on November 21, 2012 at 8:13pm

Thanks,

Here is how I got it but it is a bit messy. I had to graft the surfaces to make it work with more than one.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service