Grasshopper

algorithmic modeling for Rhino

Creating ClosedPolyLines from Proximity2D

I was hoping to take this list of lines or their points and create closed polylines from a collection like this.... I would like to end up with cells... similar to what are given from the standard Grid Components, but naturally they would have anywhere from 3 and up number of segments. and none would be contained by others.

I am at a loss as to what strategy to pursue... or if this is even possible without using galapagos.

Thanks for any advice.

Views: 310

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on December 10, 2012 at 12:59am

You can use [Surface Split], it's slow but it does the job (see attached).

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Attachments:
Permalink Reply by AB on December 12, 2012 at 12:38am

Thanks David!

That really helps... it is a little slow, but that is not a problem for my needs at the moment.

Thanks again!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service