Grasshopper

algorithmic modeling for Rhino

create a loft surface from 10 curves

Hi everybody,

i'm new to this forum and also to grasshopper so i'm having some troubles.

i'm trying to loft 10 curves i generated scaling them and moving one of them in Z direction by 1.5m in order to get a kind of freeform dome. At this point my problem is thai i have the curves in the right position but the loft command accepts only one curve. I think i have to create a sort of list in order to tell Loft which one is the first and wich one is the last but i can't found out how to do this. can anyone help me?

Views: 446

Replies to This Discussion

Permalink Reply by David Rutten on April 28, 2013 at 10:58am

Hi Mario,

Loft indeed requires all curves to be in the same list. However you don't have to create this list before using the Loft component. If your curves are in separate parameters then you can just connect them all with the Loft input by holding SHIFT while drawing new connecting wires.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service