Grasshopper

algorithmic modeling for Rhino

Hi

I can't figure it out to create a loft between two square polylines on the same plane.

Thanks

Views: 635

Replies to This Discussion

Do you need to loft them?

Would it be enough to use (Surface tab, freeform panel) "Boundary Surfaces"?

(But lofting them actually works for me)

/ola

Thanks for your reply but I am not able to loft between these two squares.

one square is an offset and the other is an offset of the first offset when joining together in a loft nothing happened!

Do I miss something?

Thanks

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service