Grasshopper

algorithmic modeling for Rhino

Could not morph multiple curves onto surface using SrfMorph component

I could do it with a single curve but not with more than 1. Attached is the file.

Thanking in advance.

Views: 400

Attachments:

Replies to This Discussion

Permalink Reply by Riccardo Majewski on October 1, 2015 at 12:49am

On the SrfMorph component, graft the geometry "G" input (right-click).

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service