Grasshopper

algorithmic modeling for Rhino

conic curves in Grasshopper?

Hi. Community

I am trying to fillet the corners of two curves. I am trying to give different lengths for each edge. Somehow it can be like conic curve in Rhino. Can anyone guide me a bit how to do it? Thank in advance.

Views: 694

Replies to This Discussion

Permalink Reply by Dedackelzucht on August 22, 2012 at 8:47am

how do you like this?

Best Regards

DeDackel

Attachments:
Permalink Reply by kwanphil cho on August 23, 2012 at 10:16am

Thanks for the reply. I don't have latest grasshopper installed yet. I will try your def as soon as i can. I also develped something quick if you want to have a look at it. I am not sure if it is right direction or not. Fillet component in grasshopper wouldn't give me the uneven distance filleting as far as I know. Thanks again Dedackel always!!

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service