Complex lofting and patching of surfaces

Hey guys so I'm having some trouble trying to create a complex surface from boundary curves that I've made. There always seems to be a problem in the corner or edge conditions that doesn't allow the surfaces to meet properly. So far I've tried lofting, patching, and edge surf. I was wondering if there's any way that grasshopper can calculate these surfaces for me, or some other command in rhino that I just don't know about. Any help would be greatly appreciated. Thanks.

Replies to This Discussion

Permalink Reply by Chris Tietjen on November 10, 2012 at 3:46am

Can you post a file? There's no way to examine this problem from a jpeg.

Permalink Reply by haley zhou on November 10, 2012 at 8:33am

Heres the file.

Thanks

Attachments:

Problem File.3dm, 2.7 MB

Permalink Reply by biboarchitect on November 10, 2012 at 3:59pm

Hi Haley;

I believe best is to create you box then trim it with your side curves.

Permalink Reply by Chris Tietjen on November 10, 2012 at 5:08pm

Here I'm starting with an extruded solid from a couple of planar curves and then I'm doing some trims with surfaces from various extruded planar curves and then finally I'm using cage edit on the resulting poly surface.