[COMP. REQUEST] Create Solid.

Replies to This Discussion

Permalink Reply by David Rutten on May 6, 2013 at 1:35pm

Done.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Ángel Linares on May 6, 2013 at 1:57pm

:) Thanks.

Permalink Reply by Jesus Galvez on May 6, 2013 at 2:28pm

What about the name? Create solid is too generic. 

Permalink Reply by David Rutten on May 6, 2013 at 2:37pm

It's called Boundary Volume. Since PlanarSrf is now called Boundary Surfaces I felt it was nicely symmetric.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Ángel Linares on May 6, 2013 at 2:46pm

It's just the name of the Rhino command...:P But Boundary Volume sounds good too ;)

Permalink Reply by Ángel Linares on May 6, 2013 at 3:05pm

Just for the people that is not patient enough...

http://www.blurrypaths.com/post/49798226487/createsolid-custom-gras...