Grasshopper

algorithmic modeling for Rhino

closing offset line problem

Hi

i joined in the grasshopper membership, very exciting!

someone please help me to make cut lines of each cells assembled at some time.

the problem is that the offsetted line from the edge of triangle does't separate even though i tried to divided up by [list item] setting the number 0 to 2.

this might be my easy slip but taking time long, so please someone help!!!

Views: 1160

Replies to This Discussion

Permalink Reply by djordje on January 25, 2013 at 7:18am

Hi Masami,

And Welcome.

I am not sure I understand what you were referring to.
The fact that outline edges of your triangular surfaces do not offset as a single line, but as three separate ones?

If that is the case, then just use the "Join curves" component before you offset them:

Attachments:
Permalink Reply by djordje on January 26, 2013 at 5:43am

Hi Masami,

That is why sketches like your last one, are always helpful, when attached in the starting post of the topic :

Sorry for the delay. Conditions in which I work these days are really not humane.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service