Grasshopper

algorithmic modeling for Rhino

Circle Tangent to 2 circles and 1 line

Hello Everyone

I need to fill the two main circles with other tangent circles

In rhino I'd use 3 tan circles but on GH the same command ask me for a center point guide and I don't know where to take that.

Can somebody help me?

I need to make this only with GH and not with plugins like kangaroo.

Thanks for your help.

ciao ciao

Views: 372

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on January 16, 2017 at 10:49am

There are often various solutions to a TanTanTan problem. The centre point guide allows you to specify which of all possible solutions you'd like. Downside of course is that you need to know roughly where the answer is going to be.

Permalink Reply by Fabrizio De Paolis on January 16, 2017 at 2:04pm
I understand that, but in this case there''s only one solution. Isn't there any other possibility to obtain what I need?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service