algorithmic modeling for Rhino
Hello everybody,
So I'm drawing a chain necklace and because I want to print them I want to draw it in a spiral.
The problem here is that the first 2 chains will stay in the same place and the second 2 chains will have to rotate. Everything is going well from this point.
So when I build my necklace further I notice that the third section of the chains won't stay on the other 2 when rotating and that makes it impossible to make my necklace and the spiral because the chains have to click into eachother and have to stay on the same point.
I have a feeling that it will be a very easy solution but I can't find it and looking at other discussions I noticed that everybody uses a line in Rhino and that's not my purpose here.
I put to images down below so look at the planes that aren't on the same points and I also put the Rhino file in here and will put another response with the grasshopper file.
I hope somebody can help me because it's my graduation project and I'm getting a bit frustrated!
Thanks everbody
Noana
Tags:
So nobody would or could help me with this but if found the solution. So if somebody has the same problem here is the answer!
Welcome to
Grasshopper
© 2024 Created by Scott Davidson. Powered by