Grasshopper

algorithmic modeling for Rhino

Center point of voronio pattern as control points on surface

Hello,

I would like to crate a voronio pattern and then get the center point of the voronoi cells as control point on a surface. Any tips? Attached is a sketch of how it will look like more or less. 

Views: 280

Attachments:

Reply to This

Replies to This Discussion

This post might help, although it's about mesh subdivision. The center point of each mesh can be thought as a control point

http://www.grasshopper3d.com/forum/topics/custom-radial-mesh

Explode to faces or cells, and get center/centroid

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service