algorithmic modeling for Rhino
Cannot loft a list of lists with two curves in it. Can someone please help me with it?
Hi,
I'm trying to create a wall of louvers. I ended up with a list of lists with two curves in each list. I tried to loft the lists of curves, but it is not lofting the curves and I can't figure out why it can't.
Thanks in advance
Views: 331
- Attachments:
-
-
Louvers_02.gh, 21 KB
-
Replies to This Discussion
-
Permalink Reply by Hyungsoo Kim on
-
Like this?
- Attachments:
-
-
Louvers_02_re.gh, 21 KB
-
-
-
Permalink Reply by Ranj on
-
Finally... Thank you very much for your help. I forgot to use the original poly lines as the start of the lofts and the manipulated ones as the second curve.
- Attachments:
-
-
Louvers_02.gh, 21 KB
-
-
-
-
Thanks for your reply, but the it should be open at the places where it is pulled out. Similar to: http://www.torabiarchitect.com/blog/?p=45
I think I have made a mistake earlier on -
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Recrusive Split
Added by Parametric House 0 Comments 0 Likes
-
Table Field
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
