Grasshopper

algorithmic modeling for Rhino

Can i split open and closed curves from one node into two lists?

I have used planes to cut a surface, which gives a list of curves. I was wondering if its possible to split these into two groups in a simple way?

I have used curve/analysis/closed, but i don't know what to do next.

Views: 433

Replies to This Discussion

Permalink Reply by Vicente Soler on October 1, 2009 at 9:53am
You want to use the 'dispatch' component under logic-> list.
Connect to the 'L' input the list of curves, and to the 'P' input the 'C' output of the 'closed' component.
Permalink Reply by Dusan Bosnjak on October 1, 2009 at 12:16pm
Many thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service