Grasshopper

algorithmic modeling for Rhino

Hi all,

I am trying to using the nesting component in order to prepare a surface for laser cutting. 

But  the brep component fails to receive date. Any one knows a possible solution?

Thanks 

Nat

Views: 1111

Attachments:

Replies to This Discussion

As far as I can see, the only error that shows in your definition is the Brep-Plane component failing for one plane because the plane does not intersect the brep. That is the right-most plane. Also, I'm not quite sure what you're trying to achieve, what is going to be lasercut?

Hi Thomas,

You were right I didnt realize that the curves should be sectional lines of the surface.

What I want to do is to distribute the section curves on the two production sheets related to U and V directions, so that I can offset them afterwards in order to make a parallel series of ribs to laser cut.

Hmmm, I'm still not sure exactly what you're trying to accomplish, but have you looked into wafflescript?

Perhaps like this:

http://www.grasshopper3d.com/forum/topics/a-solid-waffle-for-laser

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service