Grasshopper

algorithmic modeling for Rhino

Bounding box

Hi,

I have some curves, not intersecting each other. I want to find a bounding box that contains them all. I can't find a simple way of doing this, can someone point me in the right direction?

Views: 318

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on May 27, 2011 at 9:01am
The Bbox component with U set at true should do the work.
Permalink Reply by Simon Kallioinen on May 27, 2011 at 2:07pm
I thought I'd seen such a component... I found it now by searching. In which menu is it placed, I was looking all over for it earlier?
Permalink Reply by Yoann Mescam (Systemiq) on May 27, 2011 at 2:15pm
Surface->Primitive

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service