Attractor Point Failure

I created origami structure and i want to make it to behave with attractor points.

I manage to make with attractors but not the correct way. So i want your help again.

Each of the parts should work by their own, where is the problem i couldn't figure it out yet. How i need to think to solve that problem.

Thank You!

Attachments:

anizotropi.3dm, 178 KB
anizotropy001.gh, 23 KB

Replies to This Discussion

Permalink Reply by Danny Boyes on May 12, 2014 at 8:05am

Hi again,

There are somethings that you need to change the order of in your algorithm. For instance: rectangular array your basic geometry first then apply the rotation and mirroring and lastly the polar array.

There is some data matching to do with regard to your reference planes but I think the attached file goes someway to getting the results you need you just need to sort the Remapping out and I think you're there.

It's also common practice here not to close off discussions affording everyone else the chance to participate, sometimes years from now. Plus in GH there is always more than one solution to a problem and if you take the first suggestion it is not always the best.

Attachments: