Grasshopper

algorithmic modeling for Rhino

Adding cutouts to surfaces with SurfSplit

Hi guys, I am trying to achieve circlular cutouts in two lofted surfaces, one above the other. While this works with the first cutout pair, the consecutive ones do not follow the same trim sequencing. I suspect my lists are the cause of this problem, but as a beginner, I'm really not too sure. I thought connecting additional cutout definitions to the working one would work. How can I make the 2nd and 3rd cutouts (outlines seen in model), and add subsequent ones?

Thanks!

Views: 291

Attachments:

Replies to This Discussion

Permalink Reply by MARIO VERGARA on May 27, 2014 at 3:18pm

Something like this?

Attachments:
Permalink Reply by Richard Y on May 27, 2014 at 3:57pm

YES! Thank you so much. Now that I see the solution it's so obvious hahaha

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service