Grasshopper

algorithmic modeling for Rhino

2 point Rectangle origin

So I think I am missing something with the 2 point rectangle component. I set the size of rectangle this case 6,5,0 but when I plug in the base plane for a different origin it doesn't move that new base plane.  It is still at 0,0,0

Views: 1383

Replies to This Discussion

Permalink Reply by Dennis Nelson on September 26, 2013 at 7:58am

Actually was able to get what I want with the rectangle component and a domain.  Which from the looks of is actually the right component for what I needed.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service