Grasshopper

algorithmic modeling for Rhino

Tijl Uijtenhaak's Discussions (28)

Search Forum

View

Discussions Replied To (14) Replies Latest Activity

"Thanks David, that seems to solve it for now!  Tijl"

Tijl Uijtenhaak replied May 8, 2017 to Voronoi Component errors

 2 May 8, 2017
Reply by Tijl Uijtenhaak

"Hi Giulio,    This does help, but again changing the number to say 3 it creates an o…"

Tijl Uijtenhaak replied Feb 11, 2011 to trouble with section cuts and planar surfaces

 8 Feb 11, 2011
Reply by Giulio Piacentino

"For the top part of the GH file it would be perfect if I could realy make a volume o…"

Tijl Uijtenhaak replied Feb 10, 2011 to trouble with section cuts and planar surfaces

 8 Feb 11, 2011
Reply by Giulio Piacentino

"Found the problem with open Breps.  This causes non closed section lines and therefo…"

Tijl Uijtenhaak replied Feb 9, 2011 to trouble with section cuts and planar surfaces

 8 Feb 11, 2011
Reply by Giulio Piacentino

"All,   After emailing my trouble to Giulio of McNeel he found out that the section o…"

Tijl Uijtenhaak replied Feb 9, 2011 to trouble with section cuts and planar surfaces

 8 Feb 11, 2011
Reply by Giulio Piacentino

"extra file of zoomed in trouble, the two lines crossing and both becoming the sectio…"

Tijl Uijtenhaak replied Feb 6, 2011 to trouble with section cuts and planar surfaces

 8 Feb 11, 2011
Reply by Giulio Piacentino

"Hi Giulio,    thanks for the useful tips once again! The only thing i'm still strugg…"

Tijl Uijtenhaak replied Dec 22, 2010 to Use pythonEditor to run grasshopper

 16 Apr 5, 2011
Reply by Giulio Piacentino

"Giulio,   It has been a while, but back with questions again.. I've been trying to u…"

Tijl Uijtenhaak replied Dec 20, 2010 to Use pythonEditor to run grasshopper

 16 Apr 5, 2011
Reply by Giulio Piacentino

"Hi David, Unfortunately i can only work with Python (until now). But it must be poss…"

Tijl Uijtenhaak replied Dec 3, 2010 to Use pythonEditor to run grasshopper

 16 Apr 5, 2011
Reply by Giulio Piacentino

"David, I've been going trough some older posts and one of your comments is: "But no…"

Tijl Uijtenhaak replied Dec 2, 2010 to Use pythonEditor to run grasshopper

 16 Apr 5, 2011
Reply by Giulio Piacentino

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service