Hannes Löschke's Discussions (1,185)

View

Discussions Replied To (1159)	Replies	Latest Activity
"here you go " Hannes Löschke replied Dec 20, 2012 to Series of numbers where each value increases by percentage of preceding value	2	Dec 20, 2012 Reply by Bret Vanderhyden
"Galapagos can only maximize or minimize. A ration(division) can deviate from 1 in bo…" Hannes Löschke replied Dec 20, 2012 to galapagos threshold	7	Jul 4, 2014 Reply by Pablo Desvignes
"Don't know how you imagine this to work in practice. You can't rotate one without to…" Hannes Löschke replied Dec 20, 2012 to picking one point from a folded plate-fold,unfold it-the rest stays in it´s shape	2	Dec 21, 2012 Reply by Martyna Ziolkowska
"Actually your logic was not too far off. With a two input component you get a cross…" Hannes Löschke replied Dec 20, 2012 to Data Tree for Orient Problem	8	Dec 20, 2012 Reply by Hannes Löschke
"You can see what I changed after the FaceVertices and recreate that on your own. Up…" Hannes Löschke replied Dec 20, 2012 to Mesh to Surface In GH	5	Dec 20, 2012 Reply by Hannes Löschke
"Can't see the where you get the 32 geometries and 40 planes. Anyway, there are over…" Hannes Löschke replied Dec 20, 2012 to Data Tree for Orient Problem	8	Dec 20, 2012 Reply by Hannes Löschke
"Check your folding lines. Some of them are polylines. RotAx can only deal with lines…" Hannes Löschke replied Dec 20, 2012 to dividing surface-rotating elements-connecting elements-make it one surface	7	Dec 20, 2012 Reply by Martyna Ziolkowska
"Is this what you want? Just connected the 4 Points of each Mesh Quad to a 4PtSurface." Hannes Löschke replied Dec 20, 2012 to Mesh to Surface In GH	5	Dec 20, 2012 Reply by Hannes Löschke
"By straight you mean Line-like? If so, just put all your curves through a Line Param…" Hannes Löschke replied Dec 20, 2012 to how can i choose all straight crvs among a lot of curve?	1	Dec 20, 2012 Reply by Hannes Löschke
"Scaling of t (or UV for a surface) depends on local control point density, which in…" Hannes Löschke replied Dec 20, 2012 to Curve parameter	2	Dec 20, 2012 Reply by Nicolas