algorithmic modeling for Rhino

Forum Discussions (33,607)

Sort by: View

Discussions	Replies	Latest Activity
Grasshopper modeller needed. Hello, I'm looking for a Grasshopper freelance modeler for a project, if you are interested please contact me through private message. Than… Started by Francisco Gomez in Discussion	0	Oct 4, 2010 Reply by Stan Vinokur
Organizing datas Hello, I have a problem in organizing some data in a list.I have a list of points created by the intersection of 2 sets of curves and I wan… Started by Alessandro Ronfini in Discussion	0	Oct 4, 2010
line through point Hi all, I am just starting to use grasshopper and I have a simple question.How to make a line\curve passing through a point. I divided a c… Started by carlo maria morsiani in Discussion	0	Oct 4, 2010
Sorting points to draw separate curves Hello, I have went through some "sorting points" threads already but didn't find the answer, so I would like to ask if anybody could pull… Started by Matylda in Discussion	3	Oct 4, 2010 Reply by Matylda
Help! How to create a surface from the different set of points or curves. Hi to all, I'm new to Grasshopper, I'm having problems to create a surface from a set of lines and or points in a basic form I achieved. M… Started by Daniel Simonini in Discussion	0	Oct 4, 2010
Have to run rhino 4 sr8 as Admin in W7... ... because if not GH 0.7.0052 won't run. Is there a solution for this problem? Is not so bad, just a little bit annoying that I have to r… Started by carlos lara in Discussion	0	Oct 4, 2010
Problems working in the y axis I always hate posting problems like this because I know I'm going to see it as soon as I leave this forum. ok the problem is I'm trying to… Started by Nels Long in Discussion	3	Oct 4, 2010 Reply by Nels Long
SDivide gives me two 0s and two 1s, instead of 0,1,2,3 Want to draw a line from one corner to the other in a subsurface i have, i divide the srf in 1U and 1V, so i could get the four points P an… Started by dani bas in Discussion	7	Oct 4, 2010 Reply by Nels Long
Waffle Structural System, Help ! Please Help ! I attached a ghx which is created by Andrew Payne. My problem is that i can not project the parts of it. I think there are so… Started by Miklós Hatvani Deák in Discussion	2	Oct 4, 2010 Reply by Miklós Hatvani Deák
attractor on loft surface vertically Hello there, can anyone advice me on how to create openings on the loft surface vertically? Cheers Started by andrewchow in Discussion	2	Oct 3, 2010 Reply by andrewchow