Forum Discussions (33,608)

Sort by: View

Discussions	Replies	Latest Activity
Mesh to surface Dear community, Is there any way of converting mesh to one single nurb surface in grasshopper or rhino? Please help Started by kwanphil cho in Discussion	4	Apr 28, 2012 Reply by Arthur Mamou-Mani
Cull points on Surface based on surface curvature? Hi I am trying to remove points on surface based on the curvature of the surface, where the curvature degree is large there will be less po… Started by Shkattii in Discussion	0	Apr 27, 2012
math problem hi guys: i have this problem and my math skills are not go good i have 4 points all moving on the z axis: point 1 is at 0 (fixed) point 2… Started by MARIO VERGARA in Discussion	6	Apr 27, 2012 Reply by MARIO VERGARA
Invert Selection.. Hi Everyone.. I am not good at Writing english . I chose some points. I just wanna Invert selection Points. But, I don't know how to ch… Started by Blueprint042 in Discussion	2	Apr 27, 2012 Reply by Blueprint042
Planar hexagons... My dear friends... I try to do something like the picture... But I have problems because when I divided the surfaces and I make hexagons… Started by Danny Andrés Osorio Gaviria in Discussion	0	Apr 27, 2012
Dispatch according to number on list Hi guys, I am trying to separate a list of objects in order to edit them further on. I have use the dispatch but it seems that is failing… Started by Natasa in Discussion	2	Apr 27, 2012 Reply by Natasa
Neighbors Hi,I have this structure consisting of 28 panels. Based on a mesh structure, I've extracted all edges and offset them inwards). Now, if I w… Started by Claus Rytter Bruun de Neergaard in Discussion	0	Apr 27, 2012
Help! Panelling surfaces explosion Hi, When trying to panel a number of surfaces at once my target boxes seemed to explode over my model (see screen shot). I have a complica… Started by Carly Mallon in Discussion	0	Apr 27, 2012
GH Version 0.8.0062 crash on start GH installed over RHSR9 without problem, but when enter Grasshooper to start it crash. Error is attached. It might be after install Autodes… Started by Roberto Vdovic in Errors, Bugs and Oversights	8	Apr 27, 2012 Reply by Danny Boyes
Attractor points to control pipes on surface of sphere Greetings! I am new to the site and equally new to grasshopper and am in need of some assistance. What I am trying to accomplish is to plac… Started by N. Mill in Discussion	1	Apr 27, 2012 Reply by Dedackelzucht