Grasshopper

algorithmic modeling for Rhino

combination of loads

hello.iwant to combine load case of dead load and live load and wind load and then input them to karamba for analyse what can i do .in the picture i have 3 point load 1 is for dead and live loade 2 are for wind load.

Views: 321

Attachments:

Replies to This Discussion

Permalink Reply by Jaeman PARK on July 17, 2016 at 3:05am

Hi Sepide,

To combine loads, all the load should have same number of the load case. And then you can select your load case on [ModelView] component. The load case will be zero if you don't input any number to "LCase" input.

In this case, you don't need to input different numbers to "LCase" input. Just connect all your loads to [Assemble] component.

Best regards,

Permalink Reply by sepide shoaee on July 17, 2016 at 6:41am

thank you

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service