Grasshopper

algorithmic modeling for Rhino

to Rotate legend according to Rhino Cam

Hi LB community, I hope you can help me.

I want to perform a environmental section where i want to show radiation results on a vertical plane. I have this problem (you can see in the attached file): Is it possible to rotate the legend segments according to vertical plane?

Thank you in advance!

Views: 617

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by lukanuts on February 13, 2016 at 5:41am

This are the test point!

Permalink Reply by Mostapha Sadeghipour Roudsari on February 13, 2016 at 7:56am

Looks like a bug for when you just have a single surface with no context but it should not make an issue in your case. Keep the test points closer to the surface. Looks like you have set distance from surface to a very high number which will gives you a wrong result.

In any case you can use create legend component to create your own legend based on the results of the analysis and orient them to the camera.

Permalink Reply by lukanuts on February 13, 2016 at 9:31am

Thank you for your rapid reply. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service