Grasshopper

algorithmic modeling for Rhino

Hi everyone,

I'm trying to align some profile sections using using vectors normal to a mesh.

It seems like that both ggProfileOnCurve and ggSweepProfile are not working. On the other hand if I input the same vectors to the ggSAPCreateElement component everything seems working fine in SAP2000.

I tried to update the BullAnt plugin but the errors are the same.

Any help would be extremely appreciated!

Thanks

Views: 786

Attachments:

Replies to This Discussion

I suspect the bullant plugin has a flaw in it, that it's takes a point to orient to (I didn't test, but try adding the orientation vector to the start of the line and wiring that in for orientation).

I'd recommend using the IFC plugin anyway, then you can take the model to revit, archicad, etc etc.

Refer attached.

Cheers,

Jon

Attachments:

Thank you very much Jon!

It actually worked with the SweepProfile component but not with the ProfileOnCurve one!

I just needed it for representation purposes as that the Sap component was working perfectly.

Is it possible to link directly the IFC plugin with SAP? (please forgive my ignorance) 

Thanks a lot again!

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service