algorithmic modeling for Rhino

Tangent Force
  • Male
  • Los Angeles, CA
  • United States
Share on Facebook

Tangent Force's Groups


Tangent Force's Page

Profile Information

Company, School, or Organization

Tangent Force's Blog

Shatter Problems (Trim Contour Curves at Intersection, Join With Zigzag Curves, Output : One continuous PolyLine)

Hey everyone,

Objective: I am trying to make a simple extruder toolpath generator. After getting the contour paths, I am intersecting them with two perpendicular curves. The region between the two curves are to be trimmed away. The Shift list setup is to inter-connect the separate contour paths as one polyline.

Problem: I am stuck at the shatter step after CCX. I am guessing I need to path map in order to shatter correctly however I have never used this…


Posted on July 21, 2015 at 11:29pm — 3 Comments

Comment Wall

You need to be a member of Grasshopper to add comments!

Join Grasshopper

  • No comments yet!





  • Add Photos
  • View All

© 2018   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service