Jacky Lee's Page

Jacky Lee replied to Jacky Lee's discussion surface subdivion plane

"oops don't worry found a solution using evaluate surface"

Dec 8, 2011

Jacky Lee posted a discussion

surface subdivion plane

Hello one noob question: After I subdivide a surface with isotrim/divide domain, I used brep area to define that center of those divisions, then I am wanting to generate circles on that surface but the planes should be along the surface, not just simply x/y/z plane. How do I generate the circles to the different planes of the surface??See More

Dec 7, 2011

1 Comment

Awunyo Doris left a comment for Jacky Lee

"Good Day, How is everything with you, I picked interest on you after going through your short profile and deemed it necessary to write you immediately. I have something very vital to disclose to you, but I found it difficult to express myself…"

Dec 6, 2011

Jacky Lee replied to Jacky Lee's discussion Attempt to write my own grillage definition but... NEEDS HELP please ><

"OMG thank you so much!! but i used clean tree after the end points and before the flatten. not sure if thats the right way but nevertheless you are super awesome!!! thank you heaps :D"

Dec 5, 2011

Systemiq replied to Jacky Lee's discussion Attempt to write my own grillage definition but... NEEDS HELP please ><

"Using Clean Tree on section curves should help."

Dec 5, 2011

Jacky Lee posted a discussion

Attempt to write my own grillage definition but... NEEDS HELP please ><

Hi everyone, I have attempted to write a definition that gives me the sections and then offset it, then create end points for both curves to join those end points up for a planar surface. the definition works fine with a surface ive been making but when I change it to another similar surface, the data matching for the end points wont match up and acts crazy!! can any experts please shed some light in this situation when the same definition is used to two different surfaces? i dont understand…See More

Dec 5, 2011

2 Comments

Jacky Lee is now a member of Grasshopper

Dec 5, 2011

Welcome Them!