JYOTI SHARMA's Page

"Thanks Adam...It worked really well.."

"Hi Jyoti, one simple way to find the mid point of each subdivision is by using Evaluate Surface. When You edit component you might setup U and V parameters to 0.5 and remember to reparametrize input S. All best "

"Hi JYOTI; try entwine. hope helps ;)"

"Hi Danny I have not referenced any geometry from Rhino. However Please find attached the grasshopper defination. Thanks a lot for ur interest."

"Hi David, Thanks a lot for your reply... Flattening did work ...however I was thinking if there is any way to make the path similiar without adding any additional steps to make the paths equal."

"Unfortunately you chopped of the most interesting part of you image, the actually data path structure displayed in the panel. It would help a lot if you could upload your definition with any referenced geometry so I can work with the structures as…"

"Hi Jyoti, you'll need to change the data-paths to match up as well. Flattening the inputs of a Merge component will do this, but it may destroy too much information depending on your specific case. -- David Rutten david@mcneel.com Poprad,…"

"in the voice of Sir David Attenborough: for all twitchers out there here is another fine example of a change to the gui in the next release. see how the red colouring of the arrows has been unified to signify the chinese year of the dragon :)"

"Thanks David... It worked."

"Polygon Center will do what you need. Curve Tab, Analysis panel. -- David Rutten david@mcneel.com Poprad, Slovakia"

"Thanks for the reply Danny. However, the average component gives me the mean of all the corner points of all the cells in the grid but not the centre point of each individual cell of the grid. How should i go about finding the centre of each cell in…"

"use the average component to find the center point of the corner points. maths tab > util panel"