David's Page

David replied to Daniele Profeta's discussion Length Crv in Feet and Inches

"What are the units in your Rhino project set to?"

Nov 2, 2012

David replied to David's discussion Flow Along Curve?

"Ok, I figured it out. I used the domain component tool to extract the domain value, then multiplied it by value sliders from 0-1. Thanks for the help again, Chris."

Oct 29, 2012

David replied to David's discussion Flow Along Curve?

"I was assuming that perp frames were being placed along the curve according to a length parameter, not the domain parameter. This is problematic because if I rebuild the curve or select a new curve, the domain value changes and therefore my sliders…"

Oct 29, 2012

David replied to David's discussion Flow Along Curve?

"Chris, Thank you very much for your help. That is a huge step in the right direction. Unfortunately when I applied that workflow to my geometry, one of three things happens. 1. I cannot use a value of 100% of the curve length to place my final…"

Oct 29, 2012

Chris Tietjen replied to David's discussion Flow Along Curve?

" "

Oct 25, 2012

David posted a discussion

Flow Along Curve?

I had an initial workflow in Rhino of taking 5 curves, lofting them, then flowing the loft along a curve (Flow) to get my final result. I was able to recreate the final model in Grasshopper by distributing the profiles along the curve and then lofting that, but I'd really like to be able to use flow along curve (Flow) so I can place the profiles in a non regular fashion. The method I ended up with utilizes PFrames which only allows regular divisions. I'd much rather be allowed to "weight" the…See More

Oct 25, 2012

4 Comments

David is now a member of Grasshopper

Feb 11, 2010

Welcome Them!