Spatial Truss (WIP)

As part of an ongoing research on parametrics, this definition is our first attempt to understand the solution to an old problem in spatial structures.

Here it goes: Tetra.Tesselation.07.ghx

What it does: from a set of curves (might be splines, straight lines or closed plines or splines) it generates a lofted surface, subdivides it into an U&V grid and constructs a spatial mesh.

Next Post >

Comment

You need to be a member of Grasshopper to add comments!

Comment by shehzad irani on October 5, 2013 at 12:27am: Hi Charles.

have you taken the definition off? or the link is not working?? I am unable to download from the link above..

regards

Comment by djordje on November 30, 2010 at 4:22pm: Ok I downloaded the Tetra.Tesselation.07.ghx and it works fine. Thank you.
But now, I am confused with the file structure itself. There is so much in it, I do not know wich nodes and lines do I need to connect from the Rhino to Grasshopper?

Comment by djordje on November 29, 2010 at 8:02am: I tried using your Tetra.Tesselation.07.ghx and I am still getting the same result.

Comment by Charles C Vincent on November 29, 2010 at 8:02am: Hi, Djordje,
I've corrected the Tetra.Tesselation.08.ghx and it now runs in GH 0.8.0003
Bear in mind that this is a pretty WIP definition, though!
Best,

Charles

Comment by djordje on November 28, 2010 at 3:00pm: I can not open your "Tetra.Tesselation.08.ghx". When I try to do this, I get this message:

[quote]Grasshopper Event Log

--------------------------------------------------------------------------------

This document contains the messages that were recorded during the most recent Grasshopper® file read/write. Whenever a read/write operation fails or behaves unexpectedly, this summary will be compiled and put on display. If you experience problems saving or opening files, please include this log with any bug-report you file. You can use the Send... button to mail this report directly, or you can save the log and attach it to a personal email message. This log contains no personal information beyond what you supply, nor any other information that is not directly related to Grasshopper.

Developer contact

Message log start (chronological):
--------------------------------------------------------------------------------

The remote name could not be resolved: 'www.w3.org'
[/quote]

I am using Rhino 4.0 SR8, I tried to open your .gsx file using both Grasshopper 0.8 Revision 01 and 0.7 Revision 57, but in both cases I got the same upper message.

Where am I wrong?