Grasshopper

algorithmic modeling for Rhino

Kane Borg's Blog (6)

Transmute Workshop 2014

Transmute Workshop 2014, Malta

Sublimation was a collaboration between three architects and 15 students from the Faculty…

Continue

Added by Kane Borg on November 28, 2014 at 4:00am — No Comments

Prototyping for highrise office building

Added by Kane Borg on August 3, 2013 at 2:19am — No Comments

Trade off Optimisation

  After the prototyping stage, the three objectives of Structure, Environment and Efficiency were run on Octopus to find the best trade-off designs, from which a final solution was extracted manually. Structural efficiency extracted by the use of Karamba's section optimisation tool with multiple load…

Continue

Added by Kane Borg on August 3, 2013 at 2:00am — No Comments

Evolutionary Algorithms applied to optimisation of trusses.

Trusses Warren/N-Pratt 3D Trusses Optimised using Octopus, Galapagos & Karamba.

2 Load cases; Wind load + Dead load, Superimposed Service load + Dead load.

Multi Objectives; Depth, Weight, Deflection.…

Continue

Added by Kane Borg on May 1, 2013 at 4:00pm — No Comments

Optimization of a Warren Truss

Link : Optimization of a Warren Truss

Optimization of a Warren Truss using Karamba and Galapagos. 2 Load cases considered {Dead + Snow} and {Dead + Wind}. Purlin spacing adoptable (limited). Key : Red ¬ Compression Blue ¬ Tension

Added by Kane Borg on January 8, 2013 at 6:30am — No Comments

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2021   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service