Grasshopper

algorithmic modeling for Rhino

Idtasos's Blog – May 2010 Archive (1)

problem with sweep2rail command and remote panel

I try to create a surface with the sweep2rail command by choosing the 2 circles as the 2 rails and the curve as the section curve but nothing is being created (pic1).

In rhino if i use the command sweep2rail a surface is created allright! (pic2). What is wrong?



Also when i open the remote panel nothing appears! And this is happening to all the definitions i try. Why? when i try populate a panel… Continue

Added by idtasos on May 13, 2010 at 3:57am — 7 Comments

Monthly Archives

2010

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service