Grasshopper

algorithmic modeling for Rhino

Marianne pasqueli's Blog – December 2015 Archive (1)

Trim curves that are outside a form in Grasshopper?

Question.. i want to cut the curves that are outside a form just like the fonction trim in autocad? is there a simple way to trim or split or itnersect curves with other curves or curves with lines? i dont find a solution so far.. I did the Curve/Curve than the Shatter component and finaly the Cull Pattern Component to remove all the parts that I don't want but it's not working very good. I probably did it the wrong way. I went to many differents sites to figure it out but still don't get…

Continue

Added by marianne pasqueli on December 24, 2015 at 8:41am — 4 Comments

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service