Grasshopper

algorithmic modeling for Rhino

Views: 416

Comment

You need to be a member of Grasshopper to add comments!

Comment by ĐỒNG VIẾT NGỌC BẢO on March 25, 2014 at 6:44am

@Kaazim Khan: this process is quite simple. My mass is based on Metaball. the result is mesh but it not seem to be easy to adjust some following step as NUBRS. therefore, i used contour component to get the isocuvres of the mass. after that, these curve are lofted to create Nurbs surface. finally, i used some simple method to make triangle holes and attractor. 

Comment by Kaazim Khan on July 27, 2012 at 3:26am

Hi ĐỒNG ,

i was wondering if you can share your process in arriving  at the above ...! ! 

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service