Grasshopper

algorithmic modeling for Rhino

Shell Star: Temporary Installation for the Hong Kong Detour Festival, November 29 - December 16, 2012.
Schematic Design: Andrew Kudless / Matsys
Design Development and Prototyping: Andrew Kudless and Riyad Joucka
Digital Fabrication and Assembly: Riyad Joucka, Art Lab, and Andrew Kudless

Views: 446

Albums: Shell Star
Location: Hong Kong

Comment

You need to be a member of Grasshopper to add comments!

Comment by Site Dead on December 10, 2012 at 11:06pm

Thanks,

You answered some of this down stream.. sorry for that.

I have cut this material on a router but, not a knife... looks like laser worked well.

I couldn't tell if it was kiss cut or not for the folds.

thanks for the reply. cool project...!

Comment by Andrew Kudless on December 10, 2012 at 8:04pm

Material thickness was 4mm. After folding the flanges and joining to an adjacent panel, this made the joints have a thickness of 16mm. The orientation of the flutes were aligned with the primary direction of the forces going down the shell.

It was cut on a laser cutter (actually 3 lasers each with beds measuring 1.2mx1.2m). Ideally, we would have cut it with a large format knife cutter with an attached crease wheel for the folds. However, arranging that in the length of this project (7 weeks) from halfway around the world was too difficult. Next time...

Comment by Site Dead on December 10, 2012 at 7:02pm

Thanks for sharing :0

he material thickness is..?

was this cut on a Knife plotter...?

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service