algorithmic modeling for Rhino
Node - Chair, final assembly
Nodes printed in Nylon with carbon pultruded rods (this was a big mistake as they are very brittle along their lengths)
University Final year product design project
Comment
-
Comment by martyn hogg on May 14, 2015 at 4:22pm
-
the rods will seem brittle because the stud is going inside them which exerts a lot of force that tries to split the rids. If the rods pushed inside the corner pieces it would be much stronger but possibly not look so good.
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Twisted Groove
Added by Parametric House 0 Comments 0 Likes
-
Field Dendro
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!