Grasshopper

algorithmic modeling for Rhino

Good news, bad news...

The radial grillage fabrication utility is as finished as it's going to be for while, but sometimes it locates notches on the wrong edge.

For the vertical sections in this example (it might be too tiny to see clearly) all the notches should be located on the vertical edge.

If you use the definition, check any output for vertical ribs. The notches will be the correct length, but each notch might need to be mirrored vertically about itself. The notches can be trimmed out with the older stand-alone gFAB_trimSections.ghx definition.

I'll fix the problem when I get a chance...

Views: 745

Comment

You need to be a member of Grasshopper to add comments!

Comment by taz on October 28, 2009 at 8:03am
Fixed the glitch! Go here to download the newer version.

The center of the radial grids need to be located within the BRep (you can see the hole in screengrab above) but I'm working improving that.

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service