Grasshopper

algorithmic modeling for Rhino

These 4 knobs are each connected to a 10 kohm potentiometer and then wired into an Arduino Uno board. Via USB cable into my computer where the Firefly component in GH reads the values. It works great and it's very fun to adjust a 3d model in this rather "direct" way...

Update: If you want to try this at home, please check out http://www.fireflyexperiments.com/ and download the Primer. You'll find almost everything explained in there. I ordered an Arduino Starter Kit from a Swedish site http://www.electrokit.se/moduler-mikroprocessor-arduino-starter-kit-mah-uno_12200001 and then I got some more potetiometers and some knobs.
I've put this in a case now, see here http://www.grasshopper3d.com/photo/hardware-remote-control-v2

Views: 583

Location: Stockholm

Comment

You need to be a member of Grasshopper to add comments!

Comment by Matt Gaydon on February 1, 2011 at 1:37pm
Great Idea... I am guess you could attach other sensors as sliders too like, Pressue and Flex sensors to look a shaping and deformation forms...... Flex Sensor + Tapeworm Anyone :)
Comment by djordje on February 1, 2011 at 8:51am
great invention!
Comment by Mårten Nettelbladt on January 31, 2011 at 3:34pm
Ha ha, thanks!
Comment by Ivan Kiryakov on January 31, 2011 at 3:29pm
nice! tapeworm party! :D

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service