Grasshopper

algorithmic modeling for Rhino

Views: 603

Albums: sculpture

Comment

You need to be a member of Grasshopper to add comments!

Comment by Artur Bauer on August 4, 2010 at 3:13am
Hi Wieland, thanks a lot i found my problem ! my scale was to small. Now it is bigger and it looks better. Thank You very much!
Comment by Wieland Schmidt on August 2, 2010 at 1:05am
Hi Artur, make sure your metaball 'sections' are close enough then meshfrompoints generates a clean surface. Gruss nach Stuttgart, Wieland
Comment by Artur Bauer on July 30, 2010 at 12:36am
hi Wieland, my question is the way an till the metaball operation is o.k and it works. but how can i make a nice membrane like you have ?? After i do the meshfrompoints , i have open and broken holes in my structure!!
Comment by Wieland Schmidt on July 26, 2010 at 4:40am
hi philipp, to] is right thats the way its done.
Here it is described in detail:
http://ledatomica.wordpress.com/2010/04/11/organic-mesh-modelling-i...
Comment by to] on July 26, 2010 at 4:21am
hi philip
you could not loft geometry like that
continuos nurbs surfaces could not branch
this is geometry is created with the metaball plugin and meshfrompoints
Comment by Philipp on July 26, 2010 at 3:33am
how to do this (how to loft sections like this?)

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service