IMG_20140604_175649

Comment

Comment by MARIO VERGARA on June 5, 2014 at 1:49pm

well this is printed on a stratasys (powder) not plastic, so you don´t need support material

Comment by tibor on June 5, 2014 at 1:07pm

now i try similar, but my goal is to 3d-print severally each "node" with half-tentacle, because our 3d-printer is very expensive and would use too much support material...

Comment by MARIO VERGARA on June 5, 2014 at 12:12pm

that is correct tibor

Comment by tibor on June 5, 2014 at 9:24am

perhaps a skeletal mesh from a 3d voronoi diagram with thickness...?

Comment by Nezumi on June 5, 2014 at 7:06am

Hi~ realy impressive work. Is it a minisurf>.<?