Grasshopper

algorithmic modeling for Rhino

Chestnut stained, laser cut, birch plywood; stained glass; lamp parts.
Design uses Substrate component.
(visit http://manyphotons.com/lamps/terra/ for more info)

Views: 313

Albums: Terra Lamp

Comment

You need to be a member of Grasshopper to add comments!

Comment by djordje on April 14, 2013 at 4:08am

Thanks.

Comment by Mark Foxworth AIA, LEED AP on April 13, 2013 at 6:29pm

Just to add, the "expression" at the Offset is a "-D".  Loose Offset works well too.  Basically you are just offsetting curves in one direction (positive) and the other (negative), lofting, finding the edges, and then joining.

Comment by Mark Foxworth AIA, LEED AP on April 13, 2013 at 6:25pm

Thanks.  I had help with the definition, though I can't find the link to the discussion now.  Some wonderful person created this Centerline Wall definition that I just adapted for use with Substrate.  I found it works well with other definitions that don't ready offset.

Comment by djordje on April 13, 2013 at 6:11pm

Very nice. You used the "Substrate" component? How did you thicken the lines?

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service