algorithmic modeling for Rhino
hauer_drillcycles4
This one worked well. Here I am using a 1.25" bowl cutter style endmill and I am running it to a depth of .07" at an interval of 1.5".
Albums: Hauer Style Drill Patterns
Comment
-
Comment by machinehistories on December 3, 2010 at 6:39pm
-
yeah that's pretty much it. I ran the drill cycle on a given grid with a shaped endmill. I then flipped the sheet and drilled the other side using a grid which was transformed 1/2 the x y spacing of the grid. - thanks
-
Comment by Mehmet Ali on December 3, 2010 at 6:08am
-
Excuse me for a very beginners question. Is the process how I imagined? : You have made a grid and at each intersceting point you made a hole to a thick material after all holes have been made you turned the material to other side and you aligned the material and made the hole just by positioning the material to the unholed grids. Is it correct? Fascineting work..
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Twisted Groove
Added by Parametric House 0 Comments 0 Likes
-
Field Dendro
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!