Grasshopper

algorithmic modeling for Rhino

Another exercise for the GHL2 workshop, displaying the Principal Stress Curve of a mesh generated using Kangaroo.

In the words of Jon Mirtschin: "The Principal stress directions should give indications of structural grid alignment. It indicates the directions of greatest axial thrust. Material performs best under direct axial stress rather than shear/flexure. Think of a truss rather than a beam. A truss you are arranging the material in a geometry where everything primarily is loaded in the longitude direction. A deep beam has lots of material in areas where it's not really needed (or not used to full advantage). So a grid aligned on a surface according to principal stress should be more efficient than one that is not."

Views: 406

Albums: Simply Rhino Workshops
Location: London

Comment

You need to be a member of Grasshopper to add comments!

Comment by Jon Mirtschin on April 1, 2012 at 9:52am

My vector field to flowlines component is still a bit coarse (it was a quick implementation of a strategy I derived for producing an indicative result).  I never had a chance yet to test with SPM but would be interested to see if it (or any other tools) produces a better result.

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service