Grasshopper

algorithmic modeling for Rhino

Eurekka

Views: 931

Albums: Grasshopper

Comment

You need to be a member of Grasshopper to add comments!

Join Grasshopper

Comment by Nitant Hirlekar on November 5, 2015 at 10:16am

just explode the Deluanay Mesh and take its Edge Curve and then Join Them Take center point and then Extrude to point then again explode that Brep ..

Cheers

Comment by bhavin nagda on October 22, 2015 at 9:46am

how can i sub divide the deluanay surface to achieve this kind of pattern please help with some solution

thank you 

Comment by behdad on April 16, 2012 at 11:30pm

VERY NICE SURFACE.

Comment by Isak Bergwall on November 18, 2011 at 10:51am

This is amazing!!

 

I have been trying to figure out how to achieve the kind of surface you have in the middle and to the right. Is there any chance you could give me some tips or even let me see the ghx file? I would really appreciate it!!

 

you can email me at isak@aftermath.se if you have the time!

 

Thank you!

Comment by Hrvoje Petrovic on November 18, 2011 at 8:13am

Great!

About

Translate

Search

© 2020   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service