Grasshopper

algorithmic modeling for Rhino

Views: 277

Comment

You need to be a member of Grasshopper to add comments!

Comment by martyn hogg on September 1, 2014 at 10:45am

there are 3 types of connectors for a geodesic. I generate them from the lines that meet at each node.

Comment by 未知 on July 17, 2014 at 2:49am

That's good
These connectors are the same?

Comment by martyn hogg on January 23, 2014 at 5:13pm

Finally manged a boolean split to remove the slot in the corner pieces between the struts. Also created a hole for an M6 cap screw with a nut recess on the back and then split the corner piece in half so it would actually be possible to assemble :)

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service