Grasshopper

algorithmic modeling for Rhino

Bracelet design using Cocoon plugin. Remeshed in Zbrush.

Views: 523

Comment

You need to be a member of Grasshopper to add comments!

Join Grasshopper

Comment by HEEN on February 4, 2017 at 1:29am

thanks  make some tutorials :P

Comment by AJ on December 29, 2016 at 6:37am

great design Shridhar. did you made the curves grow with anemone? where they created around a mesh surface?

thanx . again very impressive

Comment by Shridhar Mamidalaa on November 10, 2016 at 6:08pm

Hi HEEN try the Cocoon Plugin it helps build such geometries from points,curves adn Breps.The rest is upto users creativity. :)

Comment by HEEN on October 25, 2016 at 11:55am

Oh this is nice can you give me some introduction to create something like that??

Comment by Shridhar Mamidalaa on September 24, 2016 at 10:47pm

Thank u for your interest . I used Grasshopper for generating these series of curves. on a base pipe geometry. and used Cocoon on them. 

Comment by DoradoZYL on September 24, 2016 at 10:12pm

Nice job! How do you get these lines, can you give a hint?

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2020   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service