Grasshopper

algorithmic modeling for Rhino

A simple definition for arraying and scaling a geometry. I do not know why it creates duplicates when is baked, I delete them with SelDup command on Rhino command line. Also it works only for low number of array. Definition is in the comments.

Views: 113

Comment

You need to be a member of Grasshopper to add comments!

Join Grasshopper

Comment by emmasmith Smith on Monday

Thank you so much for this. I was into this issue and tired to tinker around to check if its possible but couldnt get it done. Now that i have seen the way you did it, thanks guys
with
regards

https://plex.software https://kodi.software/ https://luckypatcher.pro/

Comment by Fakinos Konstantinos on August 2, 2019 at 8:07am

A little revision for 360 degree direction placement of array on xy plane.Array & scale 2

Comment by Fakinos Konstantinos on August 1, 2019 at 10:44am

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service